Product
Sample images
Fitting Vehicle model
2007- Fiat500 & Fiat500C
DOESN’T fit 2016- facelift
models without any minor change.
Procedure
1.Clean the area around emblem on the upfront bumper, especially around emblem. and wait until the area perfectly dries up.
2. Perform a few test alignments to get comfortable with your planned placement. put temporary on front emblem, marking your planned placement with masking-tape.
Make sure with no space between the surface and EmblemGuard.
3. Apply ethanol to the bonding surface and remove all dust and wax completely.
4. Hold the parts with a soft cloth without scratching the plating of EmblemGuard.
Attach and apply gentle pressure to ensure the EmblemGuard has made full contact with the surface and fully bonds by double-sided tape.
5. Make sure with no space between the surface and EmblemGuard, and wait for 24hours.
During that time, DON’T touch and vibrate.
CAUTION
- the parts don’t easily make full contact with the surface due to the conditions of the surface, caused by damage ore aged deterioration. keep trying until fully bonds without scratching parts.
- parts doesn’t include emblem itself.
- DOESN’T fit vehicles mentioned above. don’t apply other vehicles.
- don’t keep using the parts when NOT fully bonded. otherwise it may fall down.
- don’t peel and install the parts. this may weaken tape’s adhesive strength and cause to fall down.
- when peel and install again, surface should be completely cleaned up without any adhesive residuals. apply tape primer on the surface and use a new both side adhesive tape.
- plating of emblem is easily scratched. so use a soft cloth when cleaning the emblem.